Compressed air system in factory plays an important role. In order to ensure the stable operation during the manufacturing process, the regulary maintenance is nescessary . However, there are many different problems in fact such as: Air compressors, dusty air dryers, high engine room temperatures, unsecured wind convection ... lead to reduce using  time of compressor accessories (air filter, oil filter, oil separator ...). On the other hand, the recommended  maintenance   in some factories is not seriously followed and there are deviations. To extend the life of the machine as well as compressor components and ensure operator safety Air compressors are very important to maintain regularly and technically correct.Air compressors, dusty air dryers, high engine room temperatures, unsecured wind convection ... lead to reduced use time of compressor accessories (air filter, loc oil, oil separator ...). On the other hand, the maintenance (maintenance) recommended by the manufacturer in some factories is not guaranteed and there are deviated. To lengthen  longevity  of mạchine as well as compressor components and ensure operator safety , air compressors are very important to maintain regularly and technically .

Shutdown for a prolonged period Handsome II air compressor

• When the compressor is not used for a prolonged period, be sure to turn off the earth leakage breaker.
• When the compressor is not used for a prolonged period, be sure to close the discharge  air valve.
• It’s recommended to perform a break-in once  a week for about 20 minutes to keep the machine in good order and to prepare for the next operation. Follow the steps described in (3) Instruction for operation on page 5-4 for break-ins.
• If any abnormal conditions are detected, request a service in order to ensure a trouble-free run at the next operation.
• Follow the steps described in (3) Instruction for operation when resuming operation.

 Daily maintenance Handsome II air compressor.

Adjusting safe valve.

• Adjustment proceduce.

Adjust  the safety valve in the following sequence if the set pressure drops.

1. Turn the lock nut B anti-clockwise.
2. Turn the nut A clockwise to increase the release pressure. The release pressure of the safety valve is increased by approx.0,1 Mpa ( 1kgf/cm2) when the nut is turned by approx.90 degrees. The set pressure for HN37:0,83Mpa (8,5 kgf/cm2). The set pressure for HM37-uH : 0,97 Mpa (9,9 kgf/cm2)
3. After setting the pressure, turn the lock nut B clockwise and fasten it ( Consult with our workshop for detail.

     Part number (common of all types).

Cleaning dust filter Handsome II air compressor.

• Cleaning
• Remove the dust filter  cover and take the filter out.
• The filter should be either vacuumed or cleaned with water.

                             Part number.

Cleaning suction filter Handsome II air compressor

• Cleaning

• Remove the cover, take the element out and clean it by blowing air from the inside. Change the element if it’s badly clogged.
• After cleaning , fix the element to the body firmly and attach the cover.

                                                    Part number.

                                                                             (Common to all types)
 


 
Minh Phu provides maintenance and repair services for air compressors, in addition Minh Phu also provides spare parts for air compressors with high quality at reasonable prices. For further information, please contact (+84)919 23 28 26. Sincerely thank you for your interest and your trust of our service.